【1】
O/H repair |
【2】
After starting O/H, we couldn't detach at all due to rot,
Grind off metal cap, fixed female screw of cylinder side. |
 |
【3】
Assembled new metal cap temporarily. |
 |
 |
【4】
Temporary assembled complete. |
 |
【5】
Disassembled temporary assembled and metal cap,
attached o ring with metal cap. |
 |
 |
【6】
Assembled metal cap and piston temporarily. |
 |
 |
【7】
Temporary assembled of metal cap and piston was complete. |
 |
【8】
Applied grease to female screw of cylinder side. |
 |
【9】
Inserted metal cap and piston temporary assembled. |
 |
 |
【10】
Insert piston into cylinder,
After adjusting female screw and metal cap,
enclosed metal cap. |
 |
 |
【11】
Complete all piston, metal cap inserted. |
 |
【12】
After insertion, applied liquid seal packing for metal to metal cap and female screw. |
 |
 |
【13】
After applying liquid packing,
attached thrust washers to metal cap,
sealed thread portion. |
 |
【14】
O/H completed.
Connected unit, added pressure, and tested it.
Test was OK, and repair completed♪
|